Skip to main content

QR Code

Add a QR code to a form, choose its destination, and verify the result by scanning it.

Add a QR code to a form so people can open a web address from their phones. For example, use a shared link to equipment instructions or give each equipment record a code that opens its own page.


Add a QR Code control to the form

In the form designer’s controls panel, find QR Code and drag it into a section or container. Select the control to open its settings.


Set the link and appearance

In Appearance, use Size to set the code size in pixels. Use Align to place it on the left, in the center, or on the right.

Under Link Address, choose how to set the destination.

  • Current item uses the web address of the record displayed on the form.

  • Specific Address uses the URL you enter. For a URL that depends on the record, open the expression editor next to the address field and bind the appropriate field or expression.

The QR Code Appearance panel showing Size, Align, Link Address, and Dynamic Display Rules.

If the code should only appear in certain situations, configure Dynamic Display Rules and preview a case where the code should appear and one where it should be hidden. Dynamic display rules


Adjust spacing and test the scan

Use Advanced to adjust the spacing around the code. Preview the form and scan the code with a phone to confirm the destination. If the address depends on the record, test two records with different destinations. For an internal record, verify access using an account with the expected permissions. Advanced options

To print labels for multiple records, place a QR code in each collection item and bind it to the current item’s data. Check the codes and their labels in print preview. Printing multiple records with a collection


​

Did this answer your question?